One Mfg Cupcake Stomp Pad

One Mfg Cupcake Stomp PadFrosty cupcake snowboard stomp pad traction pad. Clear Material with our new and improved cone shaped stud design over our classic My Backyard graphic to give your boot more traction on the board when getting off chair lifts or riding with one foot strapped in. Keep your foot where it should be. Make your board look tasty. Oneball molds and then produce this pad in our Belfair Factory! Size: 5"x4" Instructions: 1. Clean board surface and dry

Frosty cupcake snowboard stomp pad/traction pad. Clear Material with our new and improved cone shaped stud design over our classic My Backyard graphic to give your boot more traction on the board when getting off chair lifts or riding with one foot strapped in. Keep your foot where it should be. Make your board look tasty. Oneball molds and then produce this pad in our Belfair Factory!

Size: 5"x4"

Instructions:
1. Clean board surface and dry completely. Use ONE MFG Base Cleaner, rubbing alcohol, or another solvent may be needed to get off dirt. Let the solvent dry for 10 minutes.
2. Mark area where pad will be placed with pencil first. Peel off backing of pad. Place stomp pad in front of your back foot binding and center edge to edge.
3. Only stick once, do not move, making sure not to damage adhesive. Use your fingers to press on pad with firm pressure. Use a hair dryer or heat source to help the pad stick if you want.
4. Let stomp pad adhere to board for a minimum of 12 hours before using. Better yet, bring your board inside your home and let the stomp pads rest overnight.